Constantly breaking parts2018-05-23T06:22:49+00:00

Forums Niryo One Troubleshooting Constantly breaking parts

Viewing 1 post (of 1 total)
  • Author
    Posts
  • eyalu
    Participant
    Post count: 1

    The printed parts are constantly getting worn during use. I literally had the arm operational for 3 hours for the past 2 weeks and had to already print several parts. The base is super-fragile, so that was printed 3 times already…

    Did anyone try to print the parts from a more sturdy material? I’m especially concerned about going to a more elastic material like nylon since many screws are screwed directly on to the printed parts and I fear that I’ll just move the problem from one area to another 🙁

    Any help will be appreciated, it’s very frustrating to have a 1400$ arm sit on my table doing nothing.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.