Looking for the settings used to 3D print replacement parts2018-09-19T18:15:44+00:00

Forums Niryo One 3D printing Looking for the settings used to 3D print replacement parts

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • GShipman
    Participant
    Post count: 1

    Hello,

    I am looking for the layer height, infill and other variables to re-print parts I have broken and that were broken upon receipt.

    this is for the Archive 1.1 version.   Even though I received in Sept the 2.0 documentation does not match the kit I received while the 1.1 version does.        The nut recess for the M4 nut on the metal arm to plastic body was to tight a tolerance and when trying to seat the nut the part broke.       The control board tray had one of the elevated mount screw supports broken upon receipt.   I am currently gluing the parts to get around the breaks but would appreciate the details so I can replace these parts with fresh ones.

    Thanks Geoff

    Edouard Renard
    Keymaster
    Post count: 71

    Hi Geoff,

    We’ve sent you an email to deal with this issue, and will post a recap here after.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.