FacebookTwitterYouTubeGoogle+Rss
Lost tracking on motor 1 and 32018-04-28T08:35:32+00:00

Forums › Niryo One › Troubleshooting › Lost tracking on motor 1 and 3

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Herbert
    Participant
    April 28, 2018 at 8:35 am
    Post count: 1
    #2257

    Motor 1 and 3 isn’t giving any position feedback. Now every time i move on their axis i get an error message saying: “Command has been aborted”. In studio it says that motor one is always stuck at around 0.00 rad, and motor 3 on -1.401 after calibration. Any help is much appreciated.

    Side note: Would be really useful to be able to name the joints in Niryo One Studio

    Edouard Renard
    Keymaster
    May 9, 2018 at 8:00 am
    Post count: 110
    #2270

    Hi Herbert,

    We have sent you an email to solve this issue 🙂

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.