Forums Niryo One Troubleshooting Motor connection problem Servo axis 4

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • ingfred
    Participant
    Post count: 2

    Hi.
    I’m newbie with Niryo.
    I’ve got a Motor connection problem With servo Axis 4.
    Scan to find dxl motors show that found ids are -3 / -6 / -11.
    The servo on the elbow (dynamixel 430 is flashing when powered up, but it seems it’s not recognized by the scan.
    This servo was changed by other people of the fablab.
    Is there any thing to do to initialized such an actuator ?
    I have tested to wire directly the servo from the card and it’s the same problem. t’s not a problem of wiring.
    Could you help me ?
    Thx.
    Fred

    ingfred
    Participant
    Post count: 2

    Precision :
    All th efirmwares and softs were updated before to test the niryo.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.