Forums Niryo One 3D printing Smaller 3D printer than recommended

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • Asterion
    Post count: 2

    I have a flashforge finder as my first 3D printer.

    So, as a rough guide, how many niryo parts would not fit that printer please?

    I am assuming I can make some if not all on that printer and will have to outsource the remaining parts. I did poke around with the elbow and wrist and they, at least, seem to be doable.


    Post count: 3

    Hi !

    I’m Thomas Fom niryo .

    You need at least a 200mm*200mm*200mm 3D printer to be able to print all the parts.

    But the bigger part is : The shoulder , The Base , The drawer .

    It’s possible to print the other part on your printer

    Best regards

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.