Forums Niryo One Troubleshooting Stepper Motor Axis 4 Troubleshooting

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Erica
    Participant
    Post count: 1

    The stepper motor on Axis4 is not connected. Axis1, Axis2, Axis3 works well.

    What’s the problem?
    At first, I thought it was a problem with the stepper motor of Axis4, but it works when I uploaded the Arduino code by changing the motor in Axis4 to ID3. However, if you change the motor in Axis3 to ID4 and upload it, it will not work at all.
    If you change ID to 4, it doesn’t work at all. Am I right?
    I bought it before 2018 and recently started using it, but it didn’t work, so I left a message.
    Thank you for reading it.

     

    SparseTheory
    Participant
    Post count: 1

    Did you find a resolution to this issue – I am having the same problem. I get the “motors Stepper Axis 4, are not connected” issue as well. I have checked the cabling by swapping cables with Axis 3 and also flashing the firmware identifying it as Motor 3 – both work. So appears to be something else. Does this have to do with the older robot and new Studio (I just completed my build so first time using).

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.