Forums › Niryo One › Troubleshooting › Unable to update V1 rpi image
Tagged: format, SD capacity
Was able to perform flash of niryo_one…2_0_0.img using Etcher on SD card from V2 robot,
but not the SD card from V1 arm MMBWB08GCK-T0 TBSS08YTAK181S (Etcher reports additional 8.39 mb required).
When USB device plugged in Windows 10 reports it must be formatted.
Format utility shows 7.25 GB capacity (I have not reformatted the drive).
Purchased PNY 16GB class 10 SD 2-pack.
Flashed with Etcher and installed updated RaspberryPi version 2_0_0 image V1 robot. Success
I think that if you reformat the card first, then you’ll be able to flash the image. We have made the image shorter on purpose (about 7.5GB instead of ~7.9GB) so it will fit on all SD cards (they don’t always have the same available space).
Also, yes, using a 16GB SD card is a fast and nice workaround 🙂
You must be logged in to reply to this topic.